06/05/2018 Horizontal Stabilizer-Drilled Relief Holes and Bent Front Spar (2 Hours)
I was a little nervous at the beginning of today’s session, because I haven’t practiced drilling relief hole or bending
Read moreMonth: June 2018
06/04/2018 Horizontal Stabilizer- Marked Bend Lines and Drill positions on Front Spar (3 Hours)
The front spar requires more work than the rear spar, because as Van’s points out in their instructions that the
Read more06/01/2018 Horizontal Stabilizer-Primed Elevator Hinge Bearing and First Mistake(1 hour)
Today I primed the hinge bearing VA-146 and a little rough area of the hinge bracket. After spraying primer on
Read more05/31/2018 Horizontal Stabilizer – Elevator Bracket and Bearing (1 Hour)
Match drilled all elevator brackets and bearings. The center hinge bearing was a little awkward to access once it is
Read more